The Flashing Arrow sign is designed to increase your business sales. With this sign, your potential customers will have a clear and easy to read directional sign on the trailer which will direct them to the correct place on your premises. This sign has a weatherproof construction with aluminum frame and heavy duty stainless steel blades for added strength. The front end is easily mounted using a hydraulic mounting system that gives a tight grip to the trailer. Flashing Arrow signs are available in various sizes to fit your requirements.
Sign is designed to withstand wind loads of up to 130 mph. The sign is provided with a sturdy metal carrying case that is designed to withstand harsh weather conditions and rugged usage. The front end of this sign is provided with a flexible hose that is capable of being folded conveniently and securely to prevent accidental leakage of water while in use. The wind sensor provides the sign with a warning signal if the wind blows too hard or too slow. The front and the back of this sign are provided with two (2) non-skid mounting points that help eliminate the possibility of damage due to skidding and slipping.
There are two types of Flashing arrow signs; namely, the Type C and Type K Temporary Gravel Sign. The type K Temporary Gravel Sign has an open design that is capable of providing the sign with good visibility even in inclement weather conditions. This is provided through the use of a non-skid frame that has been provided with an adjustable and pre-drilled mounting plate. This mounting plate is capable of being firmly fastened to the concrete surface. The front edge of this type of sign is provided with a non-skid grip.
In order to ensure that the work area is well lighted, it is necessary to install Flashing arrow sign at the work zones. The work zones are provided with directional arrows that direct traffic to the intended destination. These directional arrows are provided in both, vertical and horizontal formats. It is possible to install these signs on the road side as well as the parking lot side.
In addition to the directional arrow signs, you can also opt for the other specialized traffic control solutions that are provided by the Traffic sign Company. One such solution is the taper rectangle. The taper rectangle has been specifically designed to direct traffic towards the right (or left) turn points. The front end of this rectangle is similar to the shape of the traffic cone. The rear end is much wider and extends further than the width of the front end. It is made out of high quality polycarbonate which is capable of providing safety and durability under any condition.
Another traffic control solution that is available from the Traffic sign Company is the illuminated and sign illuminated warning lights. Illuminated warning lights help the approaching traffic know about the potential hazards and dangerous situations ahead. When driving in heavy traffic, it becomes extremely difficult for drivers to notice the approaching traffic; therefore, these signs are very helpful in increasing the visibility. The sign is illuminated on both the sides with equal intensity. It is capable of providing clear information to all motorists about the potential hazard. The sign is illuminated from two directions – the inside and the outside of the triangle.
Traffic cones can be used for temporary pedestrian access and also to control traffic. The contractor provides a complete range of Traffic Cones, which can be fixed on the sides of the road and also on the parking lots. The cones are used for temporary pedestrian access when the main roads are not suitable for pedestrians. These cones are designed to provide extra protection to the approaching vehicles and to help the approaching vehicles to enter the parking lot.
To make sure that the signal and the driveway entrances remain clean and safe for the approaching vehicles, it is important for the business owner to install the few work zone indicator. The flashings that come along with this indicator helps to identify the areas that are work zones and those that are not. The authorized material list specifies the minimum required width, minimum required height, and minimum and maximum height of the flashing indications. Once you have installed the few work zone indicator in your driveway entrance, you can ensure that there will be no confusion in the identification of the work zones.