A Netgear Nighthawk range extender boosts the existing WiFi range to a great extent. But at times, WiFi signals of your router become weaker, resulting in no internet connectivity. One of the best options to get internet range in every corner of your house is Nighthawk extender setup. Netgear Nighthawk extender helps in transmitting your router’s WiFi signals throughout your building. But sometimes, you might see a blinking orange LED after Nighthawk extender setup.
But don’t sweat over it! We’ve got you covered! In this post, we’ll provide you all the possible fixes that will help you resolve a blinking orange LED after Netgear Nighthawk extender setup issue in no time. Let’s take the plunge!
Troubleshoot: Blinking Orange LED After Nighthawk Extender Setup
Connectivity Issues With Your Router
If your Netgear WiFi range extender is unable to connect to your router, then try to restart your devices. To do so:
- Unplug your Netgear extender and router.
- Wait for 10 minutes.
- Plug your devices back in. It is suggested to plug in your router first.
Now, see if this troubleshooting tip has fixed the issue for you.
If you have ignored the extender firmware updates, then also you may experience a blinking orange LED issue after Netgear Nighthawk extender setup. Thus, to get the most out of your Netgear extender, update its firmware on a regular basis.
Improper placement of your Netgear WiFi extender can also result in the blinking orange LED after Nighthawk extender setup. Thus, to fix the issue, place your Nighthawk extender openly on a higher shelf, near to your router and away from corners.
Improper Ethernet Connection
Make sure to connect your Netgear Nighthawk extender and properly using a well-maintained Ethernet cable. Bear in mind – if your devices are not connected properly then also you may experience a blinking orange LED after Netgear Nighthawk extender setup.
Configure Your Netgear Nighthawk Extender
Ensure to set up your Netgear Nighthawk extender completely and properly using the on-screen instructions provided on mywifiext.net setup page. Partial configuration of your Netgear Nighthawk extender will also result in poor connectivity apart from blinking orange LED issue.
Remember, during the extender setup process, your Netgear Nighthawk device must be connected to your router in a wireless manner or using an Ethernet cable.
Overloaded WiFi Channels
If your Netgear Nighthawk extender is operating on an overloaded wireless channel, then also blinking orange LED issue will continue to trouble you. So, it is suggested to change the default wireless channel of your Netgear Nighthawk extender via mywifiext.
Reset Your Extender
Sometimes, even after firmware update or power cycling process, you might struggle with a blinking orange LED issue. Don’t fret out! You can easily fix the issue using the factory reset method. So, let’s guide you with this method by providing step-by-step instructions:
Note: Your extender’s personalized settings will be deleted after the factory reset process. So, it is suggested to take a backup of all the extender’s customized settings prior to performing the factory reset process.
- First of all, make sure to plug your Netgear Nighthawk extender into a working wall outlet.
- Disconnect your Netgear Nighthawk extender from your main router.
- Locate the reset hole on your extender and push it using a pin or a paper clip.
- Hold the Nighthawk extender reset hole for some time and release it.
- That’s it! Your Netgear Nighthawk extender has been reset successfully.
Now, try to configure your Netgear Nighthawk extender again by accessing mywifiext setup page . If you are still seeing a blinking orange LED on your Netgear Nighthawk extender, get in touch with our experts.